Table of Contents
|
|
|
|
|
|
|
|
|
|
|
| |
Download manual in PDF format -
[ Download ] |
|
|
Physical Details
| Twin WAN Gateway - Front Panel: |
 |
| Operation of the Front Panel LEDs are as follows: |
|
System: |
Power - |
OFF - No Power
ON - Normal Operation
|
| Status - |
OFF - Normal Operation
ON - Firmware not loaded or hardware error
Blinking - Data in/out
|
|
|
WAN: |
LINK/ACT - |
OFF
10BaseT connection or no connection on WAN port 1/2.
ON
Physical connection to the Broadband modem on WAN port 1/2 established. |
| 10/100M - |
OFF
10 BaseT connection or no connection on WAN port 1/2.
ON
Physical connection using 100 BaseT on WAN port 1/2 established. |
|
|
LAN: |
LINK/ACT - |
OFF - No physical connection.
ON - Physical connection or data in/out. |
| 10/100M - |
OFF
10 BaseT connection on the corresponding LAN port or no connection.
ON
The corresponding LAN port is using 100 BaseT. |
|
|
Front Panel Status & Error Conditions |
LED Action |
Condition |
WAN1 LINK/ACT & 10M/100M LEDs flash alternatively. |
Firmware Download in progress. |
WAN1 LINK/ACT & 10M/100M LEDs flash concurrently. |
MAC address not assigned. |
WAN1 LINK/ACT & 10M/100M LEDs solid On |
SDRAM error |
WAN2 LINK/ACT & 10M/100M LEDs solid On |
Timer/Interrupt error |
LAN1 LINK/ACT & 10M/100M LEDs solid On |
LAN/WAN error |
Twin WAN Gateway - Rear Panel:
WAN Ports - |
Connect the primary Broadband Modem to WAN 1 and the second Broadband Modem on WAN 2. |
LAN Ports - |
Connect the PCs to these ports. Both 10BaseT and 100BaseT connections can be used simultaneously.
Note: Any port will automatically operate as an “Uplink” port if required. Use a standard RJ-45 Ethernet cable to connect to any port to another hub or switch. |
Reset Button - |
Press the Reset button once for a warm reboot. To reset the Twin WAN Gateway to default settings, press and hold the reset button for 30 seconds. |
Default Settings:
When the Twin WAN Gateway has finished booting, all configuration settings will be set to the factory defaults, including:
- The IP Address is set to its default value of 192.168.1.1 with a Network Mask of 255.255.255.0
- DHCP Server is enabled
- User Name: admin
- Password cleared (no password)
|
