| Procedure |
1. |
Ensure the Twin WAN Gateway and the DSL/Cable modem are powered OFF. Leave the modem or modems connected to their data line. |
2. |
Connect the Broadband modem(s) to the Twin WAN Gateway. If using only one (1) Broadband modem, connect it to the WAN 1 port. |
3. |
Use standard LAN cables to connect PCs to the LAN ports on the Twin WAN Gateway. |
| |
 |
Both 10BaseT and 100BaseT connections can be used simultaneously. |
|
Use a standard CAT-5 Ethernet cable to connect any port on the Twin WAN Gateway to a standard port on another hub. Any LAN port on the will automatically act as an Uplink port when required. |
|
4. |
Power Up: |
| |
|
Power on the Cable or DSL modem(s). |
|
Connect the supplied power adapter to the Twin WAN Gateway and power up. |
|
5. |
Check the LEDs of your Twin WAN Gateway: |
|
|
The Power LED should be ON. |
|
The WAN – Link LED should be ON when the corresponding WAN port is connected toa broadband modem. |
|
For each PC connected to the LAN ports, the corresponding LAN LED (either 10 or 100) should be ON. |
|
